Difficulty Level

Tools/Supplies Needed:

• lithium battery model number CR2032
• coin or standard/flat screwdriver

Procedure:

• work in an area where you don't risk losing any small parts
• find a slot on the side of the case and use a coin or standard screwdriver to pry the case apart
• once apart, the battery will be exposed on the backside of the case
• the battery simply snaps into place and can be removed using your fingers
• the positive side of the battery faces the backside of the case
• a replacement battery is a lithium battery model number CR2032
• to remove the circuit board and button assembly, slowly pull the rubber push pad from the case, assisting by pushing the buttons on the opposite side
• then to remove the circuit board, unwrap the push pad from around the circuit board
• reassembly in reverse of disassembly

Frequently Asked Questions (FAQ):

My keyless entry won't work after I replaced the battery, why is that?

Try reprogramming the remote. Please refer to the steps below on how that is done.

Can I separate the metal key from the plastic case?

No you cannot. The metal key is moulded into the plastic case.

My plastic case is broken, where can I buy a new case?

A new case can be purchased at a variety of places such as from the dealer or an online source. When buying a new case, you will need the new key which comes with the case cut as well. This does not to be done at the dealer, any locksmith or a retailer with a key cutting machine can do this. Then remove the electronics from your old key fob and place it into the new key fob.

Programming Procedure

1. Enter the vehicle and ensure all doors are closed. Insert the key, then turn the ignition to run position, but do not start the engine.
2. Using a currently programmed key fob, press and hold the unlock button for four to ten seconds.
3. Within the specified four to ten seconds, continue pressing the unlock button and press the panic button as well. There will be an audible chime which indicates programming mode has been accessed. Then release both buttons.
4. You will have 60 seconds to add all new key fobs. Press and hold the lock and unlock button simultaneously for 2 seconds on the new key fob. There will be an audible chime once accepted. Within four seconds press and release the unlock button. Another chime will sound indicating the new key fob is working correctly.
5. To exited the programming sequence, turn the ignition to off and remove the key.