Difficulty Level

Tools/Supplies Needed:

• standard/flat screwdriver
• electrical tape

Procedure:

• using a standard screwdriver, wrap electrical tape around the tip so it doesn't scratch the paint
• when look at the light, regardless of which side it's on, both need to be pushed forward and unclipped from the rear
• place the standard screwdriver on the backside of the light (towards the rear of the vehicle) and push forward (to the front of the vehicle)
• now pull outward at the same time on the back of the light
• once popped out at the rear, then pull it out slightly and release the front
• once removed, disconnect the wire by twisting in a counter clockwise direction when looking onto it from the rear of the assembly
• then pull out
• in order to remove the bulb, just pull straight out
• installation in reverse